Configuring Cisco G.SHDSL wan interface card and Huawei AR1833

Cisco Router configuration 

Router>enableRouter#configure terminal
Router(config)#controller DSL 0/2/0
Router(config-controller)#mode atmRouter(config- controller)# line-term co
Router(config-controller)# line-mode 2-wire line-zero
Router(config-controller)# dsl-mode shdsl symmetric annex B
Router(config-controller)# default line-rate
Router(config-controller)# description Modem Module
Router(config)# interface  ATM0/3/0
Router(config-ATM)# description Connected To The Remote IPPhone Through L/L
Router(config-ATM)# no ip addressRouter(config-ATM)# no atm ilmi-keepalive
Router(config-ATM)# bridge-group 1Router(config-ATM)#pvc 0/35
Router(config-ATM-pvc)#encapsulation aal5snapRouter(config)# bridge irb
Router(config)# bridge 1 protocol ieee
Router(config)# bridge 1 route ipRouter(config)#interface BVI 1
Router(config-if)#ip address 172.xx.yy.193 255.255.255.192
Router(config-if)#ip pim sparse-mode
Router(config-if)# description BridgeInterface
Router(config-if)#no  shutdownRouter(config-controller)# end
Router#write

Huawei Modem

< Quidway > system-view

[Quidway]bridge enable

[Quidway]bridge 1 enable

[Quidway]  save

The configuration will be written to the device.

Are you sure?[Y/N] Y   " Enter"

Now saving current configuration to the device.

Saving configuration flash:/config.cfg. Please wait...

.......

Current configuration has been saved to the device successfully.

< Quidway > system-view

[Quidway]interface Ethernet1/0

[Quidway -Ethernet1/0]promiscuous

[Quidway-Ethernet1/0]bridge-set 1

[Quidway]quit

[Quidway-Virtual-Ethernet0]interface Virtual-Ethernet0

[Quidway-Virtual-Ethernet0]bridge-set 1

[Quidway-Virtual-Ethernet0] quit

[Quidway] save

The configuration will be written to the device.

Are you sure?[Y/N] Y    "Enter"

Now saving current configuration to the device.

Saving configuration flash:/config.cfg. Please wait...

.......

Current configuration has been saved to the device successfully.

< Quidway > system-view

[Quidway]interface LoopBack 0

[Quidway -LoopBack0]ip address 172.xx.yy.6 255.255.255.192

 [Quidway]  quit

 [Quidway] save

The configuration will be written to the device.

Are you sure?[Y/N] Y    "Enter"

Now saving current configuration to the device.

Saving configuration flash:/config.cfg. Please wait...

.......

Current configuration has been saved to the device successfully.

< Quidway > system-view

[Quidway]interface Atm2/0

[Quidway -Atm2/0]pvc 0/35

[Quidway -atm-pvc-Atm2/0-0/35]map bridge Virtual-Ethernet0

[Quidway -atm-pvc-Atm2/0-0/35]  quit

[Quidway]  save

The configuration will be written to the device.

Are you sure?[Y/N] Y    "Enter"

Now saving current configuration to the device.

Saving configuration flash:/config.cfg. Please wait...

.......

Current configuration has been saved to the device successfully