Cisco Router configuration
Router>enableRouter#configure terminal
Router(config)#controller DSL 0/2/0
Router(config-controller)#mode atmRouter(config- controller)# line-term co
Router(config-controller)# line-mode 2-wire line-zero
Router(config-controller)# dsl-mode shdsl symmetric annex B
Router(config-controller)# default line-rate
Router(config-controller)# description Modem Module
Router(config)#
interface ATM0/3/0
Router(config-ATM)#
description Connected To The Remote IPPhone Through L/L
Router(config-ATM)#
no ip addressRouter(config-ATM)#
no atm ilmi-keepalive
Router(config-ATM)#
bridge-group 1Router(config-ATM)#pvc
0/35
Router(config-ATM-pvc)#encapsulation
aal5snapRouter(config)# bridge irb
Router(config)# bridge 1 protocol ieee
Router(config)# bridge 1 route ipRouter(config)#interface BVI 1
Router(config-if)#ip address 172.xx.yy.193
255.255.255.192
Router(config-if)#ip pim sparse-mode
Router(config-if)# description BridgeInterface
Router(config-if)#no shutdownRouter(config-controller)# end
Router#write
Huawei Modem
<
Quidway > system-view
[Quidway]bridge
enable
[Quidway]bridge
1 enable
[Quidway] save
The configuration
will be written to the device.
Are you
sure?[Y/N] Y " Enter"
Now
saving current configuration to the device.
Saving
configuration flash:/config.cfg. Please wait...
.......
Current
configuration has been saved to the device successfully.
<
Quidway > system-view
[Quidway]interface
Ethernet1/0
[Quidway -Ethernet1/0]promiscuous
[Quidway-Ethernet1/0]bridge-set
1
[Quidway]quit
[Quidway-Virtual-Ethernet0]interface
Virtual-Ethernet0
[Quidway-Virtual-Ethernet0]bridge-set
1
[Quidway-Virtual-Ethernet0] quit
[Quidway]
save
The
configuration will be written to the device.
Are you
sure?[Y/N] Y "Enter"
Now
saving current configuration to the device.
Saving
configuration flash:/config.cfg. Please wait...
.......
Current
configuration has been saved to the device successfully.
<
Quidway > system-view
[Quidway]interface
LoopBack 0
[Quidway -LoopBack0]ip
address 172.xx.yy.6 255.255.255.192
[Quidway] quit
[Quidway] save
The
configuration will be written to the device.
Are you
sure?[Y/N] Y "Enter"
Now
saving current configuration to the device.
Saving
configuration flash:/config.cfg. Please wait...
.......
Current
configuration has been saved to the device successfully.
<
Quidway > system-view
[Quidway]interface
Atm2/0
[Quidway -Atm2/0]pvc 0/35
[Quidway -atm-pvc-Atm2/0-0/35]map bridge Virtual-Ethernet0
[Quidway
-atm-pvc-Atm2/0-0/35] quit
[Quidway] save
The
configuration will be written to the device.
Are you
sure?[Y/N] Y "Enter"
Now
saving current configuration to the device.
Saving
configuration flash:/config.cfg. Please wait...
.......
Current
configuration has been saved to the device successfully
